Vetusware.org: DOS » Vetusware.com updates: 2020-04-10

Home » Vetusware Updates » DOS » Vetusware.com updates: 2020-04-10 (DOS)

Show: Today's Messages :: Polls :: Message Navigator
E-mail to friend

Vetusware.com updates: 2020-04-10 [message #4285]

Fri, 10 April 2020 03:00

vetus@vetusware.com
Messages: 4070
Registered: September 2015

Karma: 12

Senior Member

BOCARAM/AT PLUS RAM Board Software [3.5'' Disk] 1.07
http://vetusware.com/download/BOCARAMAT%20PLUS%20RAM%20Board%20Software%20%5B3.5%20Disk%5D%201.07/?id=16326
Bocaram AT Plus drivers and support software

Clipper Summer '87
http://vetusware.com/download/Clipper%20Summer%2087/?id=16324
Clipper Summer '87 These files aren't from original diskettes so I did't bother to image them but, unlike all copies I could find, seem to be *complete* and the files are *unmodified*.

NCGopher 1.2
http://vetusware.com/download/NCGopher%201.2/?id=16325
NCGopher v1.2 - tfurrows@sdf.org - Public domain =========================================================== ## Introduction ## NCGopher is a simple gopher client for DOS, made for the sole purpose of having a client with decent speed that runs on an 8088. It depends heavily on mTCP's netcat utility. To be very precise, here is what you need to use NCGopher: ## System Requirements ## * 8088 or 80x86 based machine with 640kb of RAM (less?) * DOS (only tested on 6.22, but older versions should work) * Ethernet card, installed and configured * Working and running packet driver for ethernet * mTCP from Michael Brutman, https://www.brutman.com/mTCP/ * mTCP configuration to match your network, nc.exe working

Report message to a moderator

Previous Topic:	Vetusware.com updates: 2020-04-07
Next Topic:	Vetusware.com updates: 2020-04-11

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Feb 02 14:57:45 MSK 2025

Total time taken to generate the page: 0.20340 seconds